IDTF1150 Dual RF to IF Downconverting Mixer The F1150 dual channel device is designed to operate with a single 5V supply. It is optimized for operation in a Multi-mode, Multi-carrier BaseStation Receiver for RF bands from 1700 – 2200 MHz with High Side Injection. IF frequencies from 50 to 450 MHz are supported. Nominally, the […]
RF mixers reduce distortion in 4G basestations Continue Reading
The Arduino Wireless shield allows your Arduino board to communicate wirelessly using Zigbee. This documentation describes the use of the shield with the XBee 802.15.4 module (sometimes called “Series 1” to distinguish them from the Series 2 modules, although “Series 1” doesn’t appear in the official name or product description). A Simple Example You should be able
Arduino and Xbee wireless setup Continue Reading
I built a remote-controlled robotics platform using a 4WD mobile platform, an Arduino (Seeeduino Mega), an Adafruit motor shield, and two XBee radios for communication. There are also some super-bright white LEDs on the front for headlights. The point of the project was to show how an XBee radio can be used to send joystick
Wireless Robotics Platform with XBee Remote Control Continue Reading
Wireless power transfer systems are well on their way to replacing conventional wired charging. Ranging from tiny biomedical implants all the way to wirelessly recharging huge electric vehicles. An integral part of the research on wireless power is minimizing the magnetic field density. The International Commission on Non-Ionizing Radiation Protection (ICNIRP) provides scientific advice and
3-Axis Magnetic Field Sensor Continue Reading
BTW!!!!! This instructable is awsomeeeeeeThis is a very simple but at the same time a very hard project depending on your skill level. Lets get to building! What this is, is a wireless animatronic hand that doesn’t need a computer to operate. The user wears a control glove and can control the animatronic hand precisely.
Arduino Wireless Animatronic Hand Continue Reading
This project describes the first part of the following two projects: A wireless doorbell transmitter as described in this Instructable A wireless doorbell receiver to be described in the Wireless Doorbell Receiver Instructable When I am sitting in the backyard of my house I cannot hear it when somebody is ringing the doorbell at the front door.
Wireless Doorbell Transmitter Continue Reading
UPDATE: Added Schematic, Top Layer PCB, Bottom Layer PCB, and both Top, Bottom PCB images When I finished the “RevIO” – an Arduino Clone that has the different way of exposing pins usage. I decided to go further to the next project. To test my “RevIO” board that it could do the bigger task than
Make Wired Robotic Arm Edge to “Wireless” with DIY Arduino and XBee Continue Reading
As the name implies, the Arduino Wireless SD shield serves two functions. Foremost, this shield allows you to easily interface with Xbee transceiver modules to create mesh networks, and other wireless devices. Secondly, the micro SD socket allows you to store and access a large amount of data. Whether using these functions by on their
Arduino Wireless SD Shield Tutorial Continue Reading
The Arduino system offers an easy and open-source method for programming microcontrollers. Normally this means using a serial cable or USB cable attached directly to the microcontroller project. But what if your project is floating in a weather balloon, glued to the bottom of a swimming pool or baked into a loaf of bread? It would be
Programming Arduino Wirelessly Continue Reading
This is one small project which I had done with Abhinav Gupta some months back. In this experiment, I graduate from using simple RF communication to Xbee! Whoa! Ok, so here is the basic problem statement. I need to develop a temperature sensing system such that the temperature from the sensor node is relayed to
Simple Wireless Sensor Network for Temperature Sensing Continue Reading
