Simple digital cameras can produce remarkably good quality photos and are now cheap enough that it doesn’t hurt the wallet too much to buy one with the intention of modifying it for use in a project. You may even already have an old digital camera that you don’t mind sacrificing for a good cause! Modifying […]
In order to “visually” highlight the behavior of Arduino programs you must connect a device to the I/O pins, which gives you tangible signals. Normally, if you want to check if a program changes a level of an output pin, answering a command or executing a check routine, or event, you must check it by
My DIY Oscilloscope, how i got my signal Content : – Description – Screenshots – Video – Credits and links Descriptions I am experimenting with RF and IR signals in various frequencies and had some trouble with the receivers and needed to see what kind of signal i was receiving. I cannot afford a real
A simple DIY Oscilloscope with Arduino Uno and Mega Continue Reading
This summer, my hackerspace LVL1 (in Louisville, Ky) got an awesome laser cutter http://fslaser.com/40w-deluxe-hobby-laser-engraver-and-cutter. LVL1 is an awesome community of creative folks that like to build stuff. You can always check out what we are up to at http://www.lvl1.org. If you like instructables and making stuff, you should see if there is a hackerspace in
Laser cut gear clock with ChronoDot using Arduino Continue Reading
There are many electronic devices that use the SPI bus, or Serial Peripheral Interface bus, for communications (e.g. various sensors, LCD displays, digital potentiometers, D/A and A/D converters, wireless transmitters and receivers, audio volume controls). The devices receive data serially from a microcontroller using a 3-wire set-up that includes a chip select signal (usually titled
Using an Arduino to Control or Test an SPI electronic device Continue Reading
This instructable primarily shows how to control the charging voltage from a solar panel to an energy storage device (capacitors in this case). I showed how to construct the light previously http://www.instructables.com/id/Human-Powered-Light-from-my-book-Doable-Renewab/ Step 1: This solar panel can produce up to 18 volts, but my capacitor bank should never receive more than 15 volts. I
Solar Powered LED/Ultracapacitor Arduino Regulated Light Continue Reading
I developed the camera trigger unit in order to synchronize various events and actions during free-flight experiments with hawkmoths in the wind tunnel described in a previous post. More specifically, the goal was to trigger multiple high-speed cameras and have LEDs that indicate the exact timing of electrical stimuli delivered via a miniature stimulus chip
R.O.V.E.R. is an autonomous robot. He was built and designed as an interactive art installation specifically for the MAT EoYS 2013. He navigates the space with a heat array and bump sensors and interacts with attendees. When R.O.V.E.R. recognizes that a person is present he plays a song. If people are still visible and how
R.O.V.E.R.: Reactive Observant Vacuous Emotive Robot using arduino Continue Reading
In this tool-assisted education video I show how to program an Arduino Atmega2560 board in C++11 to dump a ROM chip, such as a 386sx BIOS or a Famicom cartridge ROM. I also make a ZMODEM sender and a LED blinker in this video. Sorry about the bad dub / lipsync in the beginning. I
Stage combat is the art of theatrical violence. Rather than resembling fencing, stage combat is choreographed like dance for aesthetic and theatrical effect as well as for safety. Over years of choreographing and teaching others stage combat choreography, I realized that one of the most difficult aspects of teaching someone choreography is the necessity of
Smallsword Choreography Shirt usnig arduino Continue Reading
