Have you worked with ready-made 8×8 LED matrix as displays? They come in various sizes and are quite interesting to work with. A large readily available size is around 60mm x 60mm. However, if you are looking for a much larger ready-made LED matrix, you may be out of luck. For this project, we will […]
Large 8×8 LED Matrix Display Continue Reading
Established companies and emerging start-ups are putting a stake in the Internet of Things ground, an opportunity with estimates of 50 billion devices connected by 2020. Standing in the way for many companies is the increasing complexity of technology inside connected devices. Shortened design cycles further fuel pressure felt by designers — the shelf-life of an IoT
Six boards for rapid IoT development Continue Reading
When S/PDIF became available in the Teensy Audio Library I thought this might be the solution to ground loop problems I’d been having when interfacing projects to my PC. However, I quickly realized I didn’t have any sound cards with an S/PDIF interface. In the belief that I’d rather build than buy I decided to
An S/PDIF Sound Card Using PCM2906 Continue Reading
A friend has approached me regarding his solar project. He wants to install a solar panel together with a battery and an inverter in order to have power at his allotment garden. He had looked at a hobbyist project where an arduino was used to build a MPPT (maximum point of power tracking) charge controller.
Arduino MPPT Solar Charger Shield Continue Reading
I just wanted a simle DCC central wich I can use to test new DCC locomotives n ad potentially with a “program” mode so it can “break in” new locomotives for me by running them for specific periods of time in both directions. The result is an Arduino based DCC central. It is based on
DCC mini central with IR remote control for testing locomotive decoders Continue Reading
DC Output Solid State Relay 10Amps 60V DC (Optically Isolated Input) This project has been designed around TLP250/352 which is Opto-Coupler IGBT/MOSFET Gate Driver from Toshiba and Mosfet IRFP260 from IR, This relay consists of optically isolated gate driver and low impedance Mosfet. The combination of low resistance and high load current handling capabilities make
DC Output Solid State Relay Continue Reading
Nandland Go Board – Your FPGA Playground My name is Russell and I am the creator of www.nandland.com. I started Nandland to increase the usage of FPGAs by making them easy to use. I am thrilled to announce after months of hard work the creation of the next phase of that plan: The first FPGA
Nandland Go Board – Your FPGA Playground Continue Reading
SOS is the commonly used description for the international Morse code distress signal (· · · — — — · · ·). [read more on wiki] Requirements: 1) Arduino 2*) 8 Ω speaker 3*) 150 Ω or similar resistor 4) 5mm RED LED 5) Hook-up wires 6) Any breadboard * Ω = Ohms Step 1:
Arduino SOS signal with 8ohms speaker and LED blinking Continue Reading
