Introduction This tutorial is brought to you by BreakoutBros.com. Access the complete version by following this link. Having explored the Particle Photon, I felt inclined to revisit one of our tutorials and introduce IoT (Internet of Things) capabilities using the Photon. In this guide, I will demonstrate how to enable the Particle Photon to send […]
Particle Photon Email Integration for Arduino Innovations Read More »
In this guide, learn to construct a frequency counter device utilizing an Arduino UNO board. This device showcases signal frequency values on a 1602 LCD screen. It is designed specifically to measure the frequency of PWM signals that have a peak voltage of 5V. Hardware Required: Sure, here’s a rephrased list of the components needed
Arduino Frequency Counter Tutorial for Electronics Enthusiasts Read More »
Assembly of the Female Connector Block The wiring harness has a male and female end. The gender of electrical and mechanical parts is described on this Wikipedia page. The header pins that are soldered into the circuit board for the LCD panel are plugged into the female end of the wiring harness. This web page
Wiring Harness for the LCD Panel Read More »
I’ve been working on a project that used a 16×2 LCD display and wanted a nice finish that also allowed me to seal against water and other liquids. I also needed impact resistance, low cost and the ability to be changed easily if worn or broken. I considered many different ideas:- 1) A full sheet
Home Made Bezel / Window for LCD, LED, TFT Displays. Read More »
The last couple of years I started learning about electronics from nothing to be able to build my own MIDI controllers that would serve my needs , taste and be cheaper overall in comparison with the branded products.This is CRIUS ROT8 MIDI CONTROLLER that consists of 8 potentiometers and 3 buttons with which we can
Crius ROT8 MIDI Controller [ABLETON READY – Auto Mapping] Rev1.1 Read More »
A disclaimer right up front, I didn’t shrink the remotes and that’s not a photo of my remotes through a microscope. But what I did do was shrink them down to the buttons I use the most. Not even sure what most of the others do! However, most of you will know what this image
Honey I Shrunk the Remotes! Read More »
Wassup Makers!! In this Instructables we will learn how to interface an LCD (Liquid Crystal Display) to the NodeMCU board. These 16×2 LCDs are very popular and broadly used in electronics projects as they are good for displaying information like sensor data from your project, and also they are very cheap. Step 1: Things Needed We need few components to get
Interface I2C LCD Using NodeMCU Read More »
In this short tutorial we make an Arduino LCD shield. Updated 18/03/2013 Today we are going to make an Arduino shield with an LCD module. More often than not I have needed to use an LCD shield in one of my projects, or with the Arduino tutorials. Naturally you can buy a pre-made one, however
Make an Arduino LCD shield Read More »
Displays are always nice. So far I’ve just been demonstrating how to use 7-segmented displays to display numbers using very few resources. But what if you want to display text? Or pictures? Or both? Well in order to do that, you’re going to need a simple LCD screen. Now there are simple led screens out
Arduino powered GLCD (Graphic LCD) Read More »
In this Instructables, you will see how to Interface Moisture sensor to your NodeMCU. And check the moisture value and the same to be displayed on the LCD. We’ll use Liquid Clear Crystal to display the moisture value. This 16×2 LCD is very popular and broadly used in electronics projects as they are good for displaying information like sensor data from your
Moisture Control Unit – MCU Read More »
