PIR sensors are widely used in motion detecting devices. This article is about interfacing a PIR sensor to 8051 microcontroller. A practical intruder alarm system using PIR sensor and 8051 microcontroller is also included at the end of this article. Before going in to the core of the article, let’s have a look at the […]
Interfacing PIR sensor to 8051 Read More »
A guide to getting started with the ESP8266 with the Arduino IDE This assumes that yo have a NodeMCU type board with the Silicon Labs CP2102 USB to UART Bridge. These boards are convenient because they can be connected directly to your computer for progamming and serial console. NodeMCU pin functions First install the Silicon
Nodemcu arduino interfacing project Read More »
Since the release of V-USB, dozens of projects have been made that allow an AVR to communicate over USB. USB data signals are supposed to be in the range of 2.8 to 3.6V, so there are two recommended ways to have an AVR output the correct voltage. One is to supply the AVR with 3.3V
USB interfacing for AVR microcontrollers Read More »
Introduction This is the second article in a three part series I am writing on the Arduino hardware platform. This article focuses on wiring an Arduino to a character LCD and a graphic LCD, and includes static and animated demos to show off the capabilities of each display. Character and Graphic LCDs After I initially
Interfacing an Arduino with LCDs Read More »
16×2 character LCD display is a very basic LCD module which is commonly used in electronic projects. 16×2 means it can display 2 rows of 16 characters (columns). Its other variants such as 16×1, 16×4 etc are also available. These LCDs are usually made using HD44870 compatible controllers. In this tutorial we will see how
Interfacing LCD with Arduino Uno Read More »
Arduino Uno is an opensource physical computing platform based on ATmega328 microcontroller and provides a development environment for writing software for the board. It can be used for a variety of projects. EM-18 RFID reader is one of the commonly used RFID reader to read 125KHz tags. It features low cost, low power consumption, small form
Interfacing EM-18 RFID reader with Arduino Uno Read More »
Update (6/7/2012) – I’ve had to disable comments on this post, because it is being targeted by spam bots for some reason. Please use the contact page if you have a question about this topic. In this week’s arduino tutorial, we’ll be taking a look at SPI device control using the arduino. Specifically, we’re going
SPI Interfaces using Arduino Read More »
