Hello all! In this Instructable I’ll be showing you how to make a robot similar to the “Mobile Arduino Experimental Platform” (MAEP) that I made. It is equipped with two motors that can steer the robot and the ability to see obstacles in front of it with a PING))) ultrasonic sensor. With the attached breadboard,
How To Make an Obstacle Avoiding Arduino Robot Continue Reading
I’m teaching “Electronics for Scientists” this semester, and I wanted to allow each student to have their own Arduino to play with for microcontroller lab exercises and possibly use for their final projects. The Arduino is not very expensive at roughly $30 per, but they add up quickly when you have a whole class of
“Ayrduino” Single-Sided Arduino Clone Continue Reading
Fijibot is an autonomous, self-charging photovore. I built him using a 1.5 liter Fiji Water bottle, an Arduino Uno, 6v solar panel (plus various other parts) from Radio Shack, an Arduino Proto Shield (plus various other parts) from Adafruit, and the wheels and steering arrangement from an RC car. I decided to use a Fiji
Build A Fijibot A Self-Charging Photovore Using Arduino Continue Reading
I run a NFS/NIS network under a combination of OS’s for the upper-division physics lab here at CSUC, and one source of irritation is when one machine goes down and nobody lets me know until suddenly that machine is absolutely necessary NOW! So I figured an Arduino, living in the machine on my desk, might
Network-status indicator Using Arduino Continue Reading
After seeing all the different instructables for Led cubes I was still left with a lot of unanswered questions. So after reading everything I could find this is what I got. I decided to make the instructable after building it…so ill try to recreate the process the best I can. This cube is different from others for
Make A 4x4x4 LED Cube Using Arduino Continue Reading
Lab Experiments involving the Heat Equation are usually one-dimensional exercises involving a copper pipe and a half-dozen thermocouples. But with DS18B20 “One-Wire” thermometer chips and an Arduino, it’s possible to measure hundreds of temperature values simultaneously. Here’s what my students Daniel Lund and Lawrence Lechuga and I came up with for 2-D temperature measurements. We
Quantitative Two-Dimensional Temperature Measurements Continue Reading
I was wandering the internet looking for a good Arduino tutorial on how to build a binary clock with seconds, but I could not find one. So now I am writing this for you to have a binary clock with seconds, minutes, and hours. What I did: -Because controlling 20 LEDs individually for this cube
Build A Full Binary Clock Using Arduino Continue Reading
I have constructed a basic Arduino robot arm using 3 servos that cost me £15 in total plus a couple of hours in time to build and it’s very simple that I think anyone can replicate and build this. I already had the Arduino Duemilanove ATMEGA328, some foamboard, tools and glue. The robot arm has
Arduino Robot Arm – LarryArm v0.1 Continue Reading
Overview This is a guide to building an Arduino-powered clock that uses LEDs to display a 24-hour clock (hours and minutes) as binary digits, an analog meter to display the seconds, a switch to toggle between time-display and time-setting mode, and 2 knobs for setting the hours and minutes. This was designed from scratch, but
Cwik Clock v1.0 – An Arduino Binary Clock Continue Reading
So the arm is wired into Arduino as per the previous post, Arduino: Modifying a Robot Arm and hopefully this has worked. In this next part I alter the Arduino sketch slightly and write the first Processing sketch to test control of the arm – video at the bottom. To control the robot arm we’ll
Arduino: Controlling the Robot Arm Continue Reading
