Dual 3A PSU on a Chip

Intersil have introduced a single chip just 9 x 6.5 mm which contains just about all the control features (including the output stages) needed to build a dual 0.8 to 5 V power supply with 3 A per channel output capability. The ISL8203M can also supply 6 A in current sharing operation.

Dual 3A PSU on a Chip

The ISL8203M is an integrated step-down power module optimized for generating low output voltages down to 0.8V.  The input supply voltage range spans from 2.85 V to 6 V. The two channels are clocked 180° out-of-phase to help reduce input RMS current and EMI. While in current sharing mode this interleaving of the two channels is beneficial for reducing input and output voltage ripple.

The ISL8203M has an independent power-good (PG) signal for each channel and features output capacitor discharge on power-down. Other features include internal digital soft-start, enable for power sequence, over-current protection and over-temperature protection. The chip integrates a PWM controller, synchronous switching MOSFETs, inductors and passive components to maximize efficiency and minimize external component count.


For more detail: Dual 3A PSU on a Chip

Leave a Comment

= 4 + 6

(Spamcheck Enabled)

Read previous post:
Ardu-Bot-Tom - RF Link Controlled Robot
Ardu-Bot-Tom – RF Link Controlled Robot

Introduction Ardu-Bot-Tom is a fun project created to show you how you can use wireless transmission modules to send commands...

Scroll to top