Arduino measures heart beat rate from fingertip

The PIC16F628A based heart rate meter is one of the most popular projects published on Embedded Lab. In this article, I am going to show how to replicate the same project using a simpler platform like Arduino. The Arduino heart rate meter will use Arduino Uno, Easy Pulse Plugin, and 4-digit SPI seven segment LED display module. It computes the heart beat rate by processing the analog pulse signal output fro ...

Read more

Heart On-A-Chip Beats

PORTLAND, Ore. — Living beating hearts on-a-chip were recently created from pluripotent stem cells discovered by 2010 Kyoto Prize Winner, Shinya Yamanaka. Bioengineers at the University of Berkeley aim to create all of the human organs on-a-chip then connect them with micro-fluidic channels to create a complete human-being on-a-wafer. "We have learned how to derive almost any type of human tissue from skin ...

Read more

Arduino-based Graphical Heart Rate Monitor

Introduction: Like many out there, I enjoy a good exercise session, whether it be indoors or outdoors. As part of that I purchased a Polar branded heart rate monitor, which came with a "Wearlink" chest strap and RS300Xsd receiver watch. The watch is able to do quite a bit of analysis on its own, in terms of recording heart rate averages, target zones and the like, but without the additional FlowLink device ...

Read more

Arduino – Cannot get ECG readings from heart, but I do when I poke at the leads

down vote favorite I have a minor issue with my ECG. When I poke at the leads, I get a reading. But when I hold the leads or place it near my heart, I don't get anything. I'm pretty sure this is hardware related, but I don't want to completely rule out a potential software problem. I used this YouTube video as a guide: https://www.youtube.com/watch?v=NDjRg-KgIXY, with their circuit show below. My breadboard ...

Read more
Scroll to top