This post starts a small (or larger?) series of tutorials using the Arduino Motor/Stepper/Servo Shield with the FRDM-KL25Z board. That motor shield is probably one of the most versatile on the market, and features 2 servo and 4 motor connectors for DC or stepper motors. That makes it a great shield for any robotic project
Tutorial: Arduino Motor/Stepper/Servo Shield – Part 1: Servos Continue Reading
In this instructable I will show you how to throw an Arduino motor party. I will also be giving away an Arduino Mega, Arduino Uno, and an Arduino Pro Mini. (Details at the end) Step 1: Assembly + Code You’ll need a handful of motors to throw a party. I used 2 servo motors, 1
How To Throw An Arduino Motor Party Continue Reading
It has been all dry theory in the Brushless DC (BLDC) motor with Arduino series up to this point. This is where it gets to be more fun. If you’ve just arrived, please check out the previous two installments: Driving a three-phase brushless DC motor with Arduino – Part 1. Theory Brushless DC (BLDC) motor
Brushless DC (BLDC) motor with Arduino. Part 3 – The Stroboscope Project Continue Reading
This project uses just three main components to provide forward and reverse control for a single motor. You can easily interface it to an Arduino or any other microcontroller. It’s so simple – you can wire it up “free-form” without a circuit board in about 15 minutes. Features: All parts available at Radio Shack for
Easy, Reversible Motor Control for Arduino (or any Microcontroller) using arduino Continue Reading
This little wonder of electromechanical engineering came from inside a laser diode sled of an HP CT10L Bluray drive I’ve opened some time ago. The device on the picture consists of several parts, all easily fitting on a dime coin: a bipolar stepper motor with lead screw, a linear stage, a lens, and even an
World’s Smallest Stepper Motor with Arduino and EasyDriver Continue Reading
Stepper Motor drive from Arduino In this tutorial we will show you how to connect a bipolar stepper motor to an Arduino Uno board. The stepper motor we are using is the Sparkfun Stepper Motor but you can use any other 4-wire bipolar stepper motor. Because a stepper motor draws a higher current than the
Stepper Motor drive from Arduino Continue Reading
Overview The Arduino Motor Shield is based on the L298 (datasheet), which is a dual full-bridge driver designed to drive inductive loads such as relays, solenoids, DC and stepping motors. It lets you drive two DC motors with your Arduino board, controlling the speed and direction of each one independently. You can also measure the
Adafruit Arduino Motor Shield Build Continue Reading
Using two xbees, an arduino, an xbee explorer, and an h-bridge, wirelessly control a DC motor to spin in both directions (last video). Note: I used the xbee I linked to, but for a one to one communication, rather than a network of wireless devices, xbee series 1 would do fine, but the AT commands
Use xbees (series 2) to control a motor Continue Reading
After long research and trial and error, I have came up to a new walkthrough regarding this nice chip, the L293D. Each project is one project and each one has its own unique power configurations, so you must be aware of the best battery choice and how to distribute voltage through your robot. I strongly
Control your motors with L293D and Arduino Continue Reading
