HOMEBREW COIL WINDER MAKES TOROIDS A SNAP TO WIND




Anyone who has ever wound a toroidal coil by hand can tell you that it’s not exactly a fun job. Even with the kinds of coils used in chokes and transformers for ham radio, which generally have relatively few windings, passing all that wire through the toroid time after time is a pain. And woe unto anyone who guesses wrong on how much wire the job will take.

To solve those problems, [Sandeep] came up with this clever and effective toroid winder

. The idea is to pass a small spool of magnet wire through the toroid’s core while simultaneously rotating the toroid to spread the windings out as evenly as possible. That obviously requires a winding ring that can be opened up to allow the toroid form to be inserted; [Sandeep] chose to make his winding ring out of plywood with a slit in it. Carrying the wire spool, the winding ring rotates on a C-shaped fixture that brackets the toroid, which itself rotates under stepper motor control on a trio of rollers. An Arduino controls the rotation of both motors, controlling the number of windings and their spread on the form. lacking a ferrite core for testing, [Sandeep] used a plywood ring as a stand-in, but the results are satisfying enough to make any manual coil-winder envious.




We love tools like this that make a boring job a snap. Whether it’s cutting wires for wiring harnesses or winding guitar pickups, tools like these are well worth the time spent to build them. But we suppose when it comes to toroid winding, one could always cheat.

Source: HOMEBREW COIL WINDER MAKES TOROIDS A SNAP TO WIND




Leave a Comment

*
= 3 + 4

(Spamcheck Enabled)

Read previous post:
Measure-voltage-and-current-simultaneously-with-Tiny-VA-Meter
Measure voltage and current simultaneously with Tiny VA Meter

Makers, developers and hobbyists looking for a way to measure both voltage and current simultaneously may be interested in a...

Close
Scroll to top