Digitally controlled HIFI amp with 4 way mixer




Motivation

Though I am a musician I don’t care for calling an expensive hi watt stereo my own. For years I have used a homebuilt stereo amplifier built around the TDA1554Q IC (basically just this chip in a nice box) and I am still very happy with the sound quality. This amp serves as a computer desk sound system, which acts as a radio/movie sound sytem as well.

In the meantime the number of sound sources that I want to connect to my “stereo”  has increased … suddenly there was a tablet that I use as an internet radio, a music player demon that runs on a raspberry pi and from time to time I want to listen to a podcast that I downloaded to my smartphone.

So a next-gen desktop stereo should have multiple inputs … about four of them would be nice. Also when watching TV on my computer from the bed I don’t want to get up all the time if I just want to adjust the volume. I’d like to do it digitally … maybe use my smart phone as a remote control?

Let’s summarize:

– 20 W stereo power amplifier

– 4 way audio in

– digital volume control interface

Approach

The amplifier section is trivial. You just buy a TDA1554Q, bolt it to the inside of an aluminum box, solder some resistors and capacities to the pins of the IC according to the application note in the datasheet and you have a small HiFi amplifier.

Digitally controlled

Because the volume control has to be digital, I’m using digital potentiometers. Sadly there are no (affordable) logarithmic digipots available. However I found this method which employs a linear potentiometer in combination with a fixed resistor to “fake” a logarithmic potentiometer.

READ  A Simple Arduino LED Example in Proteus

According to the article the the ratio between R1 and R2 has to be between 1:7 and 1:10 for best results. I made some calculations with octave and played around with the ratio. I found no reason against the 10:1 ratio.

t’s obvious that the voltage divider response is not exactly linear, but in the middle range it’s really pretty okay. So using a digipot + fixed resistor should do just fine for a volume control.

 

For more detail: Digitally controlled HIFI amp with 4 way mixer




This Post / Project can also be found using search terms:

  • arduino hifi
  • arduino and hifi
  • arduino hifi projects
  • hifi arduino

Leave a Comment

*
= 5 + 1

(Spamcheck Enabled)

Read previous post:
Sky on the Wall (Mood Lighting-IR remote)

I love LED and stars, and after saw another instructables about star constellation and some mood lighting that was very...

Close
Scroll to top