about controlling your system with arduino

Hi all,

First of all , i’m dutch and from Belgium.
I’m new with and for David-laser. I tried to find a clear site and list for controlling. I’ve found this schematic through ‘google’

I was wondering, can i use Adafruit Motor/Stepper/Servo Shield for Arduino kit – v1.0 instead those easydriver v3

about controlling your system with arduino

according the image:
left is the partlist from the image and at right is what i think i needed (for ordering)
1x mosfet irf540 IRF540NPBF
1x LD111 7V33 LF33CV
2x bs170 bs170 (same)
2x LM317T LM317T (same)
1x pot 10K pot 10K (same)
2x 1K 1K (same)
2x 10K 10K (same)
1x arduino UNO Arduino Uno R3 (Atmega328 – assembled) –
2x easydriver v3 Adafruit Motor/Stepper/Servo Shield for Arduino kit – v1.0
2 x steppermotor Stepper motor – 200 steps/rev, 12V 350mA

Hopely can some one confirm this list will be compatible with the schematic and code. Or newer schematics link wound be nice.

thx advanced

 

For more detail: about controlling your system with arduino

This Post / Project can also be found using search terms:

  • подключение лазера dvd через стабилизатор к ардуино уно

Leave a Comment

Your email address will not be published.

*
= 5 + 5

(Spamcheck Enabled)

Scroll to Top