DIY Arduino Unit Converter: How to use LCD

Step 1: Ingredients:

Electronics

  • Arduino
  • Breadboard
  • LCD*
  • 2x 50k pots
  • 150 ohm resistor
  • Jumper wires, and tons of them!

Unit Converter

If you do not want to use a LCD then you will have to use serial monitor. Wherever you see lcd.print just change it to Serial.print. Instead of lcd.begin change it to Serial.begin(9600);.

Step 2: The LCD

schematic Unit Converter

So the first thing I did was go to the Arduino website and see how to hook up my LCD screen. I’ve attached the schematic.
For the backlight hook up pin (K) on the LCD to ground, and pin (A) on the LCD to pin 10 on Arduino through the 150 ohm resistor.

We need to learn to how to use this LCD screen, so I’ve included a little information on this. Arduino already has a library for the LCD, so we need to include this. We can accomplish this by typing in our code before the setup, #include <LiquidCrystal.h> . Now our LCD library is included. The next thing to do is to tell Arduino what pins we are hooking up to the LCD. We do this by typing in this before the setup function, LiquidCrystal lcd(12, 11, 5, 4, 3, 2); These are the pins Arduino will send data to the LCD through.
So this is what our sketch is going to look like so far.

Now lets learn a little bit about using the LCD functions.

  • lcd.begin(16,2); // this is for setting up the number of column and rows. If you look in pictures 2 and 3 you can see the amount of columns and in picture 3 you can see the amount of rows.
  • lcd.print(” “);   // this is how we print text on the screen. Your text goes in between the the quotes. The quotes are needed.
  • lcd.clear();      // this is how we clear all text from the screen.
  • lcd.setCursor(0,1); // This is how we put text on the second row.

So put all this to a little bit of use. Hook up your screen, then type in this code.

If you copy this, paste in your sketch, and upload to your board, you should see the LCD light up and the text appear, “I’m cool”.

Troubleshooting:

  • All I see is white squares or the screen is just blue (or your lcd backlight color)!
  • The screen does not light up!

Solution:

  • Turn the potentiometer all the way to one side then the other. You should see the text appear. If so, slowly adjust the pot until the text is clear
  • Make sure all your connections are right.
  • Make sure [ lcdbl ] is set to [ OUTPUT ]

Now, lets put some text on the bottom row. If you recall, we need to offset the cursor. We do this by typing in lcd.setCursor(0,1);
See the revised code.

Upload this to your Arduino and see what happens!

Step 3: Hooking up the Second Potentiometer

Alright, now that we know how to use the LCD, we need to move one. The first step is to hook up our second potentiometer. We will do this by hooking up the two outer pins to 5v and GND, and the middle pin the Arduino pin A0.
Now of course we need to set this up with Arduino. This is how:

For more detail: DIY Arduino Unit Converter: How to use LCD

 


About The Author

Ibrar Ayyub

I am an experienced technical writer holding a Master's degree in computer science from BZU Multan, Pakistan University. With a background spanning various industries, particularly in home automation and engineering, I have honed my skills in crafting clear and concise content. Proficient in leveraging infographics and diagrams, I strive to simplify complex concepts for readers. My strength lies in thorough research and presenting information in a structured and logical format.

Follow Us:
LinkedinTwitter

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top