The above dimensions and prices reflect the Edison with the mini breakout board. I’ve been watching lots of comment channels regarding the Edison, and I see a lot of people slamming the Edison as compared to the Raspberry Pi over a few of the lines above: lack of USB (“Where am I going to plug […]
The Edison is not a Raspberry Pi Read More »
This is my homemade Dual H-Bridge using the IC L298N. For control DC motors or step Motors ao other purposes just like you need. Breakout L298N.ppt1 MB Step 1: Hardware and Materials COMPONENTS: 1 x perf board 13×26 holes (3,5 x 7,0 cm) 2 x AK300/3 connector 1 x 8 Header female connector for Arduino
Homemade Dual H-Bridge – L298 Breakout Board using Arduino Read More »
This is my homemade Dual H-Bridge using the IC L298N. For control DC motors or step Motors ao other purposes just like you need. Breakout L298N.ppt1 MB Step 1: Hardware and Materials This is the basic schematic. It works perfectly. A more advanced schematic and board for eagle cad, you can download from the link
Dual H-Bridge – Arduino L298 Breakout Board Read More »
lot has happened since our last article was published and to celebrate the continuance of bildr we’ll be playing with the MQ-3 Alcohol Gas Sensor. Coupled with the SparkFun Gas Sensor Breakout Board, connecting the MQ-3 to your Arduino is a breeze. The MQ-3 is a heater-driven alcohol sensor that outputs an analog signal (usually
MQ-3 Alcohol Sensor, Breakout Board + Arduino Read More »
After some months out, I come back with my last board, the SIM900 Breakout Board. It’s a board based on the popular SIM900 GSM modem, and I design to work with the DSETA board I develop previously. Also, the board can be used without this board, I try to design it in the way that
SIM900 Breakout Board Read More »
