Soldering an SMT MOSFET Driver with a hotplate

Soldering SMD components isn’t as hard as you might think. In fact it’s easy.
If you follow this instructables you’ll soon see just what great results you can obtain at home using just a hotplate.

Soldering an SMT MOSFET Driver with a hotplate
It’s not just being able to make small circuit boards that makes SMT soldering so good it’s also a nicer way to solder. All the ‘hard’ work is in placing the components. You then only need to reflow the solder for about 5-7 minutes and your done.

No more long soldering sessions spent hunched over a hot soldering iron breathing in all those fumes.

All you need is the PCB, some solder paste, the SMD components and a hotplate.
If you’d like a kit that includes the PCB, components and solder paste then follow this link
SMD MOSFET Driver Kit

More information is available at
www.CarbonFrog.com

Step 1: Gather all the parts

Gather and identify all the parts, remove packaging and lay out ready to be placed on the board.

Make sure you know which resistor is which, they are each marked as shown.

Also ensure that the diode will go in the correct way round. The cathode, the end you want connected to the positive rail, is marked with a line.

Step 2: Prepare the PCB

Clean the boards’ pads, preferably with isopropyl and put some flux on each of the pads. Also make sure the legs of the components are clean.

Step 3: Apply Solder Paste

Apply Solder Paste

Using a tooth pick put a dot of solder paste on each pad. Don’t use too much and avoid splats and bridges. Less is more with solder paste.

Step 4: Place Components

Carefully position each component (starting with the smallest) using a pair of tweezers. At this point a magnifying ring or head mounted magnifying goggles can really help.

WARNING! Make sure the diode is the correct way round and that the two resistors are in their correct positions.

Step 5: Setup Hotplate

Place the board on a hot plate and prepare for soldering. It is also a good idea to place the board on an aluminium plate if you have one. This not only makes it easier to move around, but also at the end of the reflow process you can pick up the plate with a pair of pliers and put it elsewhere to cool. Doing this will allow it to cool quicker and avoid over heating caused by thermal inertia.

 

For more detail: Soldering an SMT MOSFET Driver with a hotplate


About The Author

Ibrar Ayyub

I am an experienced technical writer holding a Master's degree in computer science from BZU Multan, Pakistan University. With a background spanning various industries, particularly in home automation and engineering, I have honed my skills in crafting clear and concise content. Proficient in leveraging infographics and diagrams, I strive to simplify complex concepts for readers. My strength lies in thorough research and presenting information in a structured and logical format.

Follow Us:
LinkedinTwitter

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top