Using an Apple Pro speaker, I made a flashing RGB LED iPod dock for about $35. I recommend reading the entire ‘ible before starting. Also, note that the volume is control from the iPod. It consumes minimal power in shutdown mode, and is controlled by a Teensy. This took me ~3 days to build, and […]
RGB flashing iPod dock from an old speaker Continue Reading
Concept: Very simple, using an Arduino and the play melody basic program, create a music playing speaker out of a vibration motor and a piece of flexible foam. Instead of pulsing signal to a speaker, signal is pulsed to a motor varying how fast it can spin and when it spins. Science behind it (this
Vibration Motor Foam Speaker Using Arduino Continue Reading
This instructable will show you how to use an Arduino to send and receive a variety of MIDI messages so you can start building your own MIDI controllers and instruments. First I’ll talk a little bit about MIDI protocol, if you’re just looking for sample code skip ahead to steps 5-9. If you know absolutely
Send and Receive MIDI with Arduino Continue Reading
Theremins are cool. Fact. You may also have heard of them as either aetherphone/ etherophone or termenvox/ thereminvox. Essentially its an electronic music instrument that plays a certain note depending on the position of your hand and its distance from an antenna. Building a very basic one with Arduino is easy – easier than my
Arduino – A Basic Theremin Continue Reading
This project is a part of experiments done while doing an artist in residence at Instructables. You can see the other projects here. You can use bit-shifting as an alternative way of creating “music”. This principle enables you to squeeze as much processing power as possible out of the Arduino while creating novel and interesting
Construct An Algorithmic Noise Machine Using Arduino Continue Reading
the idea of anything can be an instrumental music has been always in my mind so i made a wooden tissue box that i installed inside it a guitar of light strings Step 1: Building Box i made this wooden tissue box Step 2: Wiring we make the LDR wiring on a the top shelf of
Tissue Box Guitar – Light Strings using Arduino Continue Reading
This instructable will help you understand the iPod serial protocol, and how to send commands to an iPod using an Arduino. This instructable is only meant to show the basics of the protocol and is by no means complete. I only had enough hardware space for 4 buttons, and the software reflects that. Hardware Needed
Simple Ipod Controller using an Arduino Continue Reading
I already have one project where arduino outputs audio signal to USB speakers via software 10-bits PWM. In first, I was not satisfied with quality of sound generated via PWM. There are just not enough speed in arduino engine to run PWM well. For example for 20.000 Hz audio, PWM has to be at least 2
UnDecima Audio Output from Arduino Continue Reading
Welcome to the Instructable guide of my EL Wire hat with some fun features. The concept is an EL Wired hat with 8 sequenced EL wires controlled by a wired remote. Multiple speed controllable sequence modes are pre-programmed into an Arduino UNO, including a sound activation feature. Features: 7 sequence modes (speed controlled) 1 sound
EL Wire Hat: Sequenced and Sound Activated with Remote Control Continue Reading
The objective of this project is to build an Arduino voice shield to empower thousands of voice related applications! All this mostly thanks to an integrated ISD1790PY chip. This particular voice/TTS feature can be useful to integrate voice messages in alarm systems, to implement generic I/O controls in home automation or even in home security
A Voice Shield for Arduino Board Continue Reading
