hey guys this is my first arduino project plz comment how u feel. Step 1: Things u need As this is easy project for beginner’s so parts are also simple Parts: 1- Arduino uno or any other board will work 1-Beardboard 9- jumper wires or wires will also do 8 -leds any color u like i used
How to control 8 leds using Arduino UNO Continue Reading
LED displays are commonly packaged as arrays of LEDs organized in rows with shared positive terminals and columns with shared negative terminals, or vice versa. Here is a standard illustration, along with its diagram: These exhibits can be very useful. To control a matrix, you connect its rows and columns to your microcontroller. The columns
Arduino Row-column Scanning to control an 8×8 LED Matrix Code Continue Reading
www.ArduiNIX.com presents: ArduiNIX Nixie driver shield assembly The ArduiNIX shield is a user programmable platform for driving multiplexed Nixie tube or other high voltage displays**. The ArduiNIX is open source hardware Welcome to the assembly portion of the site. Here we will take you step by step through the build process of your ArduiNIX kit. First,
Arduino Powered Nixie Tubes: ArduiNIX Nixie driver shield assembly Continue Reading
Create your own Super Bright LED-lined sneakers that blink with multiple patterns. 1.0 FEATURES: – 1 color LEDs – 6 patterns – reed sensors + magnets that give you control to step through patterns – detachable velcro design – small, wearable microcontroller + power Step 1: Parts & Tools Parts: Super Bright LEDs (35 or
Super Brite LED Sneakers 1.0 using an Arduino Continue Reading
Step 1: IR library First you need to go to this page and download the IR library. You just need to follow the read me file to install. I think that any IR remote control can do this, I’ll be using a Philips Universal one. Step 2: Parts required Parts list: 1x Arduino 1x Breadboard
Arduino – Control LEDs with a Remote Control Continue Reading
The Siemens DLO7135 Dot matrix LED is one amazing piece of optoelectronics. It’s billed as a 5×7 Dot Matrix Intelligent Display (r) with Memory/Decoder/Driver. Along with that memory, it’s got a 96-character ASCII display set with upper and lower case characters, a built-in character generator and multiplexer, four levels of light intensity, and it all
Using a Dot Matrix LED with an Arduino and Shift Register Continue Reading
This sketch blinks the Esplora’s RGB LED. It goes through all three primary colors (red, green, blue), then it combines them for secondary colors(yellow, cyan, magenta), then it turns on all the colors to create white. For best results, cover the LED with a piece of white paper to see the colors blend. Circuit Only
Arduino Esplora Blink Code Continue Reading
It all started when I saw a BBC documentary in 2002 about deep waters of the ocean. There was a biolimunescent jellyfish in the documentary, probably of the species “ctenophores” that grabbed my attention so in the later years I decided use it as a Halloween costume. It wasn’t until 2011 when the led strips using LPD8806 driver chips
The LED Strip Jellyfish Costume with Arduino & LPD8806 Led Strips Continue Reading
I like to go skating every week but I noticed that the my skates weren’t cool enough so I decided it was time for some lights! I installed these lights on my Dad’s skates as a thank-you present for taking care of the pool for us :D. Thanks Dad! The project is just two RGB
RGB LED Skate Light Continue Reading
With this you just type the text you want on your computer and your 5×5 dot matrix shows the message. Used: ~25 leds ~Arduino uno ~5x 100ohm resistor ~and a bit of skripting It took me a while to figure this all out but in the end it was quite rewarding. not really practical though.
5X5 dot matrix on Arduino Continue Reading
