Improved Packaging and Control Generates Ultra-Fast DC/DC Converter

I wanted to have my personlal, nice looking Mediabox with a big display and remote control. I’ ve been playing around with the Raspberry for a while so I decided this would be the platform of choice for this project. I’ m actually a fan of Steampunk so I decided to use a Steampunkish style for the box.


  • Raspbmc user interface accessible via a 7″ inbuilt display
  • control via any IR remote
  • control via web interface
  • control via smartphone / tablett app
  • audio output via Cinch
  • Samba, FTP support

Step 1: Needed Parts and Tools


Here is a list of the basic parts I used for building the MediaBox:

  • Raspberry Pi Model B: 30..35€
  • a small SD card (256MB or so)
  • USB stick for the operating system (2GB)
  • USB hub with power supply
  • 7″ Display set from Pollin 39,95€
  • Edimax WLAN stick: 7,99€
  • Flirc IR remote control USB dongle: 19,00€
  • Speedlink Vigo USB soundcard: 11,95
  • wooden box from the art supply store (W240mm x H180mm x D145mm)
  • small wooden bar (about 100mm x 5mm x 5mm)
  • brass spray
  • junction box with 3 spaces
  • Velcro tape

All together the whole thing will cost you about 130€.

Improved Packaging and Control Generates Ultra-Fast DC/DC Converter


For cutting the holes in the wooden box I used a Dremel. If you don’ t have one you can use a coping saw. Also you will need:

  • sandpaper for smoothing the edges
  • wood glue for the wooden bars holding the display in place
  • wood drills for the supply cable

Step 2: Mounting the display

The display set comes in three parts: the actual display, the main board and the control panel. All three parts of are connected quite easily by plugging the flat cables in the appropriate plugs according to the manual.

READ  LT8494 - SEPIC/Boost DC/DC Converter with 2A, 70V Switch, and 7μA Quiescent Current

For mounting the display to the wooden box you have to cut a rectangle. I used a Dremel with a straight edge guide (Dremel 678) here. Surely one can also use a coping saw. Don’ t cut the rectangle to big because you have to smoothen the edges with sandpaper afterwards.

To fix the display in place I used small wooden bars and placed them inside the box around the display. Use wood glue to fix them.

I wanted the display to be removable in case something on the box has to be changed. So I decided to use Velcro Tape for fixing the display. This makes it easy to detach the display just by removing the tape. The display’s mainboard is attached to the backside of the display also with Velcro tape. It is important that the backside of the mainboard does not touch the outside of the display otherwise there will be a short. If the tape is thick enough this should not be a problem.

For using an IR remote the Flirc USB adapter needs to be applied to the front plate as well. I placed it under the display.


For more detail: Improved Packaging and Control Generates Ultra-Fast DC/DC Converter

Leave a Comment

= 3 + 0

(Spamcheck Enabled)

Read previous post:
Arduino for Photographers: Building a Universal Intervalometer

Practicing the art of time-lapse photography without an intervalometer is doable, but not particularly efficient. And while any decent photo equipment store will...

Scroll to top