A friend of mine wanted to control Cubase, his audio recording software, with a push button so that he could stop and start recordings remotely without having to go over to the computer and type on the keyboard. You may be able to do this in other recording software, we just happen to use Cubase.
Controlling Cubase with Arduino based MIDI Continue Reading
Origami is the traditional Japanese art of paper folding. In this project, with a little help from an Arduino, you can bring your origami into the 21st century and make it an interactive art! The result shown here uses Bare Conductive paint to give an origami flower proximity sensing powers. When you put your hand
Proximity Sensing Origami Flower using Arduino Continue Reading
I’ve settled on the lighting industry standard of DMX as my overall control protocol as I explore the world of blinky lights. This universal control method is electrically robust, radio transmissible, and flexible enough for my needs (not to mention the needs of major concert, theatrical, and entertainment venues.) There are a variety of DMX
DMX Ardweeny Node using Arduino Continue Reading
This project answers to a need I had: a third hand that holds a camera while I perform a test and takes photos/videos (useful when you’re stuck at the lab late at night, and suddenly need a photographer). The downside to a robotic arm was obvious – It needs to be programmed, and it is
Robot arm from a desk lamp (IKEA Tertial hack) Continue Reading
I needed a couple of AA batteries and found the display at the supermarket where they were all arrayed. Normally when I’m shopping in the supermarket, I tend to look at the price/kg or price/l when comparing similar products. In the case of the batteries, there was no such indicator. Fine, I thought, I’ll work
Measuring Battery Capacity With an Arduino Continue Reading
One of the basic tasks in many home automation systems is controlling power to appliances. They could be lights, or a heater, or an exhaust fan, or just about anything else that runs on mains power. The problem of course is that it’s dangerous to mess with mains-level power directly and you may even be
Appliance Remote Control using Arduino Continue Reading
Charlieplexing is an ingenius method for controlling many LEDs without using many microcontroller pins. You can turn on or off one LED at a time. To light more than one LED at a time, you can scan the LEDs by turning a sequence of them on and off really fast. The number of LEDs you
Charlieplexing LEDs with an Arduino Continue Reading
Hi from Italy Although many watches are created binary, my project was inspired mainly to this: http:// http://www.instructables.com/id/LED-Binary-Clock-1/, very smart and funny. I tried to improve the design and to add something personal. I think it’s a good result at the end. The project is not difficult, requires patience, it requires a little knowledge of
My Arduino Binary Clock Continue Reading
This sketch shows you how to read and calibrate the Esplora’s light sensor. Because light levels vary from one location to another, you need to calibrate the sensor for each location. To do this, you read the sensor for a few seconds, and save the highest and lowest readings as maximum and minimum. You’ll use
Arduino Esplora Light Calibrator Continue Reading
These days I was reading an interesting post on how to make yogurt “by the gallon,” which explained the need to maintain a constant temperature of about 43ºC (110°F) so the bacteria can grow properly. Commercial yogurt makers are available, but they’re usually too small for producing a full gallon at once. Building your own
Cheap Arduino Controled Yogurt Maker Continue Reading
