Hardware Preparation Stepper Motor Driver Board Arduino Board (UNO) If you bought the Arduino Board from ZTW, we have already installed the g-code library for you. If you have your own Arduino Board, you have the option to download the grbl Arduino library from the internet and upload it onto your board using xloader. Power […]
In this article you will learn how to make a digital clock using Arduino and the DS1307 RTC IC. What is DS1307 IC actually? Well, it is a Real Time Clock (RTC) IC that is simple to use, low cost and easy available. The IC basically is able to count the date and time accurately […]
In some of my previous Arduino instructurables I have show to the Arduino beginers on how to control servos in different ways. And in my last instructurable I have show the modification of a Parallax servo for a 360º rotation. So in this one I will show Arduino beginers the use of those 360º rotation servos. With that […]
Everyone loves the Simon game ! So we decided to take it to another level. This project was done for our Things That Think class where we had to make a PlushBot (a plush toy that thinks! “with computation”) thus, kids were our target.We decided on an octopus that would have all eight arms flashing, […]
This page will show you how to put together a simple stepper motor driver board that can be controlled with an Arduino. I built mine to use with my heliostat projects, but it could be used for other things too. Update: I no longer use this driver board with my sun tracking / heliostat system. […]
For a recent project I needed to build a large and obvious bar graph display. This was to show the power generated from a bicycle generator. I came up with this design and was pretty pleased with the final results as it is relatively low cost but still pretty visual. It stands 1.5m high and […]
This example shows how to simulate a simple closed-loop control algorithm in Simulink® and how to run it on an Arduino® board. Supported Hardware: Arduino Leonardo Arduino Mega 2560 Arduino Mega ADK Arduino Pro Arduino Uno Available versions of this example: Arduino Mega 2560 board: Arduino Mega2560 Drive Open-loop Arduino Mega2560 Drive Closed-loop On this […]
So you’re here because you want to start learning some of the Arduino Basics… So let’s start with THE most basics… no this “tutorial” is actually a little more basic than what you have in mind. It only requires that you: Have ANY Arduino Board. Have installed the drivers and required software for the board […]
Major corrections and additions made 9/9/2014 For my off-grid Ham Radio and Solar projects, I needed a way to measure volts, amps, watts, amp hours and watt hours. There’s a couple of commercial products that can do this, but not with the flexibility I wanted. I designed a Arduino micro-controller based solution that is very […]
Finally, I finished reading the datasheet. It didn’t give much information about how to connect the motor controller to a micro-controller. I used the simple circuit I found from a post in Pololu’s forum: Using Dual VNH3SP30 Motor Driver with arduino @ http://forum.pololu.com/viewtopic.php?f=15&t=1923. Dual VNH2SP30 Motor Driver Carrier MD03A to Arduino Circuit Diagram I connected […]
