This page will show you how to put together a simple stepper motor driver board that can be controlled with an Arduino. I built mine to use with my heliostat projects, but it could be used for other things too. Update: I no longer use this driver board with my sun tracking / heliostat system.
DIY Arduino Stepper Motor Driver Board Continue Reading
For a recent project I needed to build a large and obvious bar graph display. This was to show the power generated from a bicycle generator. I came up with this design and was pretty pleased with the final results as it is relatively low cost but still pretty visual. It stands 1.5m high and
Build A Giant LED bar graph Using Arduino Continue Reading
This example shows how to simulate a simple closed-loop control algorithm in Simulink® and how to run it on an Arduino® board. Supported Hardware: Arduino Leonardo Arduino Mega 2560 Arduino Mega ADK Arduino Pro Arduino Uno Available versions of this example: Arduino Mega 2560 board: Arduino Mega2560 Drive Open-loop Arduino Mega2560 Drive Closed-loop On this
Drive with PID Control Using Arduino Board Continue Reading
So you’re here because you want to start learning some of the Arduino Basics… So let’s start with THE most basics… no this “tutorial” is actually a little more basic than what you have in mind. It only requires that you: Have ANY Arduino Board. Have installed the drivers and required software for the board
BLINKING AN LED USING AN ARDUINO UNO (EXPLAINED) Continue Reading
Major corrections and additions made 9/9/2014 For my off-grid Ham Radio and Solar projects, I needed a way to measure volts, amps, watts, amp hours and watt hours. There’s a couple of commercial products that can do this, but not with the flexibility I wanted. I designed a Arduino micro-controller based solution that is very
DIY Amp / Watt Hour Volt Meter – Arduino Continue Reading
Finally, I finished reading the datasheet. It didn’t give much information about how to connect the motor controller to a micro-controller. I used the simple circuit I found from a post in Pololu’s forum: Using Dual VNH3SP30 Motor Driver with arduino @ http://forum.pololu.com/viewtopic.php?f=15&t=1923. Dual VNH2SP30 Motor Driver Carrier MD03A to Arduino Circuit Diagram I connected
Pololu Motor Controller Testing and Troubleshooting Continue Reading
This instructable was created to be entered in the Robot Challenge. If I win, the parts will of course, go into robots like this one. Notes on how to include some of the very components in the prize packages are given in the last step. I am 28, so of course, I’m not going for the
Arduino Nano based Microbot Continue Reading
This Arduino project is a simple light meter using a photo-transistor. An LDR would be more appropriate but the photo-transistor is what I has spare at the time. On the other hand the photo-transistor is sensitive to infrared, so its handy for testing remote controls. The project consists of 10 red LEDs driven by 10
Simple Arduino light meter Continue Reading
We can instantly open a door or control anything we can connect. It works from any iPhone, Android, or PC. After connecting something we want to control, download the free app to a PC, open a port, and control it remotely from anywhere. It’s open source so anyone can modify it to sense and control
Remote Control Door – Internet Your Thing Continue Reading
Like me, you may have a few old Arduino boards or ATmega8 chips (in the boards) laying around from when you were first playing with Arduino. Those chips can still be really useful as the heart of a tiny “Minimal Arduino” setup. A normal Arduino board contains support components that make it easy to use.
Minimal Arduino with ATmega8 Continue Reading
