Hi, in this instructable i am showing you how to build a very nice and very sturdy pan & tilt turret for your rc / arduino projects. (Please don`t judge my english grammer etc. i`m from holland) The things that you need for this project are not expansive or hard to find so it should be easy
Pan & Tilt Servo bracket controlled by Arduino Continue Reading
I had one remote controlled project that needed an Arduino running 24/7 but I didn’t want to leave my $32 Arduino UNO, so I decided to buy some pieces and created my own Arduino. The most important part was buying the microcontroller. These were my options: ATMega328P-PU with Optiboot ~ $5.50 (Sparkfun) / $5.19 (Digikey)
Burning the Bootloader on ATMega328 using Arduino UNO as ISP Continue Reading
In this Instructable we will explain how infrared signals are used by a remote to control a toy or device, then show how a simple circuit can be added to an Arduino to operate the same device through free, Open Source software. This document is part of a series covering the Puzzlebox Orbit, a brain-controlled helicopter that features
Using an Arduino to Control an Infrared Helicopter Continue Reading
I was wondering about on making a sequencer, a big 16 step sequencer was what I wanted to make. To it’s full extension with lots of features including single leds for each step, midi input and output, etc. Then I realised that I should start from a more basic model and then maybe tweak around to see
Arduino Board Step Sequencer Continue Reading
There are several good Jeopardy/Game Show lockout buttons/buzzers, but none incorporate the timing rules of Jeopardy. I am learning about the Arduino and I thought that this would be a great project to practice with. The rules include a question reading period with no timeout to reading the question. During this period, any player who
Jeopardy Ring-in Buttons with Built-in Rules using Arduino Continue Reading
Today, I’m going to show you how to make an Arduino motor shield (driver) at a low cost. It works splendidly, its posses almost all the characteristics of the original Arduino motor shield. It’s almost considered as a clone. The original Arduino motor shield has the same motor driver chip (L298), the only difference with it,
DIY Arduino Motor Shield Continue Reading
The device is based on a GSM/GPRS module with included GPS. Its main function is to detect and communicate its own geographical position using, on the choice, the cellular phone reference system or the GPS. Its small dimensions are due to the use, for the first time, of a GSM/GPRS module integrating the GPS receiver.
Localizer with SIM908 module using Arduino Continue Reading
Shield for Arduino designed and based on the module GSM/GPRS SIM900 or the GSM/GPRS & GPS module SIM908, to make calls, voice and data connections via GPRS. HARDWARE INNOVATIONS This new version (old Arduino GSM shield) has several new hardware features, that allow maximum customization and provide many configurations. We begin with the supply circuit
GSM GPS shield for Arduino Board Continue Reading
This is my homemade Dual H-Bridge using the IC L298N. For control DC motors or step Motors ao other purposes just like you need. Breakout L298N.ppt1 MB Step 1: Hardware and Materials COMPONENTS: 1 x perf board 13×26 holes (3,5 x 7,0 cm) 2 x AK300/3 connector 1 x 8 Header female connector for Arduino
Homemade Dual H-Bridge – L298 Breakout Board using Arduino Continue Reading
Let’s put together a pixel strip with an HL1606, an Arduino UNO and the Spectrum Shield to build a seven bands “large” Spectrum Analyzer of simple construction. The Strip used uses the HL1606 controller to allow direct management of each of the LEDs. The chip runs two RGB groups and has 4-pin for input/output. The
Big Spectrum Analyzer with Arduino Continue Reading
Free Arduino projects, circuits, code and tutorials. Pick a board, pick a sensor, build something.
