This instructable (entered in the Arduino Challenge contest – you can vote for it above) shows how to make a stripboard Arduino shield for programming either ATtiny45 or ATtiny85 microcontrollers with an Arduino, as per these tutorials from the High-Low Tech group at MIT: Arduino board as ATtiny programmer Programming an ATtiny w/ Arduino 1.0 …
Stripboard Arduino shield for programming ATtiny45 and ATtiny85 Continue Reading
Iβve been visiting local convenience store (Dollarama, here in Montreal, Canada) and notice nice looking FM Radio, just for only $3. Why not to try to interface it to my lovely Arduino? Idea looks quite challenging, the same time what is the point in interfacing a DSP radio shield to arduino? I donβt need a …
The Arduino Motor Shield allows you to easily control motor direction and speed using an Arduino. By allowing you to simply address Arduino pins, it makes it very simple to incorporate a motor into your project. It also allows you to be able to power a motor with a separate power supply of up to …
*NOTE* THIS PROJECT IS DONE BY A GROUP OF STUDENTS FROM SINGAPORE POLYTECHNIC Sous-vide (/suΓΒΓΒviΓΒd/; French for “under vacuum”)[1] is a method of cooking food sealed in airtight plastic bags in a water bath for a long timeβ72 hours in some casesβat an accurately determined temperature much lower than normally used for cooking, typically around …
Today, I’m going to show you how to make an Arduino motor shield (driver) at a low cost. It worksΒ splendidly, its posses almost all the characteristics of the original Arduino motor shield. It’s almost considered as a clone. The original Arduino motor shield has the same motor driver chip (L298), the only difference with it, …
