This is a set of simple, small form-factor, mini-shields that I created almost by accident. As I made more and more of them, I realized that they could be really useful. What started out as a way to use some spare parts, turned into a standardized form factor for a versatile, miniaturized Arduino shield. The
Arduino Mini-Shields Continue Reading
Connecting the Switch To connect the switch to the Arduino, you will need the switch, two jumper wires, and a 10kΩ (brown-black-orange) resistor. Once you have all the required parts, you will need to wire the switch to the Arduino using the breadboard. NOTE: The virtual board may be slightly different from the physical one.
Making a program start using a switch Continue Reading
Overview This instructable will use three photoresistors (light dependent resistors) and an Arduino to control the motion of a robot. Any common robot chassis can be used for the robot. The light sensors will be mounted on the left side, right side and front of the robot. When light of sufficient intensity falls on a
Arduino Light Following Robot Continue Reading
Motivation top We design a smart home control system which allow people control their home devices by voice command at home. This is a wireless, voice control system. People could control almost all the facilities at home including lights, fans or even back ground music. Right now, the basic function of lights control, fan control
A wireless voice-controllable household system Continue Reading
Here’s a retro hand-held gaming console I built with my son. It uses an Arduino micro-controller, a small LCD screen, push-buttons, a 3D printed case and home-grown “PC” board. It’s really pretty easy to solder and put together. My son & I wrote two games and a drawing program for it. See the video for
Magpi: The Micro Arduino Gaming Platform Interface Continue Reading
The D.I.Y. movement has many implications for the future of creativity and commerce. The impact of inventing what one needs rather than purchasing it promises to be empowering, fun, and inspirational. In a long term effort to develop dynamic computer controlled surfaces, I began exploring fluid control (in this case, compressed air) as an alternative
D.I.Y Pneumatic Linear Actuators Continue Reading
This is an explanation and set of building plans for a USB-powered sourcemeter with a personal computer interface. The sourcemeter uses an open-source Arduino microprocessor and the user interface uses the open-source Processing environment. The sourcemeter was designed as a homemade current-voltage (IV) tester to measure the IV characteristics of a solar cell by sweeping applied voltage across
Build Your Own Sourcemeter Using Arduino Continue Reading
I have a passion for coffee. I also have a passion for electrical engineering. Why not combine them? This Instructable describes how I transformed a hot air popcorn popper into a completely controllable coffee roaster! Follow these instructions to re-purpose and hack your West Bend Poppery Popcorn Popper into this coffee roaster! ———————————————————————————————– The extraction
Build a Controllable Coffee Roaster from an Air Popcorn Popper Continue Reading
Sometimes I needed an external serial monitor like the Serial Monitor in the Arduino Editor, to see what is going on. So I made one. The first picture shows an example how could be it designed. For the ESM I used an Atmel Atmega328 (based on the Arduino-Board) because it have an internal SRAM with
ESM – External Serial Monitor Using Arduino Continue Reading
The Augmented Water device helps you save water by turning red after one Liter. The device, built by @tamberg during a water hackathon, is made from an Arduino, a flow sensor and coloured LED pixels. Video https://www.flickr.com/photos/tamberg/14346321456/ (thanks kiilo) In case you want to build your own, read on… Material Arduino, e.g. http://www.adafruit.com/products/50 Ca. 7
Augmented Water using arduino Continue Reading
