About: Ibrar Ayyub

Over the years as technology advanced and grew at a tremendous pace, so did the horizon of ideas and creation in our mind. If we look a few years back, a teenager like me would dare think about creating a robot that would operate listening to their voice and follow the given commands. All they […]

Some time ago, I tried to make an “Instructables Hit Counter” using the Instructables API, and an Arduino Uno with a wired network shield. However, with the limited RAM of the Arduino Uno, I was unable to get the system to work. A while ago, I noticed a similar project done by diytronics using a NodeMCU. This was just […]

A couple of years I embarked on my own home automation project. It started off by building a server controlled 433 MHz transmitter build with an Arduino to switch lots of cheap PT2262 based remote switches. Later I added an Arduino based receiver for my weather station, hooked up the control contact of my EV […]

If you have noticed in an office before, you would be probably aware of those RFID cards or Tags that would unlock specific doors depending on your access.Well let’s make a simple NodeMCU RFID reader using the MFRC522 module, and program the NodeMCU to provide access when the right card is detected. This simple example […]

This here is my first Instructable project. So you want to get started with NodeMCU? Well, I’m here to share with you.Today, I’m going to show you how to get started with NodeMCU. Let’s GO ! NodeMCU has on board ESP8266-12E makes the board suitable for IoT (Internet Of Things). In this Instructable I will show you […]

In the previous instructable I showed you how to get started with IoT using the nodeMCU, in this instructable I will be featuring the Particle Photon which is an easy to use IoT device to get started with designing IoT projects. The particle photon is smaller than the nodeMCU and features STM32 ARM Cortex M3 microcontroller on […]

I have one M5Paper which is equipped an ePaper touch screen 540 x 960 pixels, temperature and humidity sensor, real-time clock, microSD, 03 x HY2.0-4P ports. It can connect to WIFI, bluetooth, or implement other protocols like: I2C, UART, DAC/ADC via extension ports and a magnetic attachment system…. Today, I’d like to share my home weather station […]

This project was submitted to ‘Creative Electronics’, a Beng Electronics Engineering module at University of Málaga, School of Telecommunications (https://www.uma.es/etsi-de-telecomunicacion/). It’s a modification based on sound level meters that are already marketed for use in classes to measure ambient noise. The project is developed in Arduino. It consists of a LED screen in which emoji […]

a simple 3 buttons on-off with pic12f629. it’s written with MikroC Step 1: The Code… start the code with ”int”———————————————————- int x0,x1,y0,y1,z0,z1; ////// with this the GPIO outputs could stay on or off void main() { GPIO = 0x00; ////// all outputs are 0 CMCON = 0x07; ////// Disable CMCON PORT TRISIO = 0b00111000; ////// […]

Step 1: COMPONENTS REQUIRED  Bluetooth module (HC-05) AT89S52/C51/S51/C52 microcontroller Relay Driver ULN2003A Relay Resistances and capacitors as circuit diagram depicts(below) power module(if the input is more than 5V or else not necessary) IC 7805(5V voltage regulator) 1000uF capacitor 10uF capacitor led and resistance(as per convenience so that led doesn’t get damaged) IMPORTANT NOTE: USE 11.0592MHz […]