Posts by Ibrar Ayyub:
LED Matrix with Game Controller using an Arduino
Posted on: 29 Mar 2013
This project was built for my introductory electronics class at the University of Waterloo in Canada. This was my first introduction to electronics and therefore, my first project. Follow these steps to build a 16 x 16 LED array with a wall (different colored LED on the border), powered by an Arduino Mega 2560. I […]
Sous-vide Arduino Shield
Posted on: 29 Mar 2013
*NOTE* THIS PROJECT IS DONE BY A GROUP OF STUDENTS FROM SINGAPORE POLYTECHNIC Sous-vide (/suËËviËd/; French for “under vacuum”)[1] is a method of cooking food sealed in airtight plastic bags in a water bath for a long time—72 hours in some cases—at an accurately determined temperature much lower than normally used for cooking, typically around […]
Audio Output using an Arduino
Posted on: 28 Mar 2013
Generate sound or output analog voltages with an Arduino. This Instructable will show you how to set up a really basic digital to analog converter so you can start generating analog waves of all shapes and sizes from a few digital pins on an Arduino. (This article is a companion to another Instructable I’ve written […]
Audio Input using an Arduino Board
Posted on: 28 Mar 2013
Send sound into your Arduino. This Instructable will show you how to prepare audio so that it can be sampled and processed by an Arduino to make sound responsive projects and audio effects. (This article is a companion to another Instructable I’ve written about building an audio output circuit for an Arduino, find that here) Some […]
DIY Arduino Motor Shield
Posted on: 26 Mar 2013
Today, I’m going to show you how to make an Arduino motor shield (driver) at a low cost. It works splendidly, its posses almost all the characteristics of the original Arduino motor shield. It’s almost considered as a clone. The original Arduino motor shield has the same motor driver chip (L298), the only difference with it, […]
Arduino Board Step Sequencer
Posted on: 26 Mar 2013
I was wondering about on making a sequencer, a big 16 step sequencer was what I wanted to make. To it’s full extension with lots of features including single leds for each step, midi input and output, etc. Then I realised that I should start from a more basic model and then maybe tweak around to see […]
Localizer with SIM908 module using Arduino
Posted on: 23 Mar 2013
The device is based on a GSM/GPRS module with included GPS. Its main function is to detect and communicate its own geographical position using, on the choice, the cellular phone reference system or the GPS. Its small dimensions are due to the use, for the first time, of a GSM/GPRS module integrating the GPS receiver. […]
GSM GPS shield for Arduino Board
Posted on: 23 Mar 2013
Shield for Arduino designed and based on the module GSM/GPRS SIM900 or the GSM/GPRS & GPS module SIM908, to make calls, voice and data connections via GPRS. HARDWARE INNOVATIONS This new version (old Arduino GSM shield) has several new hardware features, that allow maximum customization and provide many configurations. We begin with the supply circuit […]
Easy Bluetooth Enabled Door Lock With Arduino + Android
Posted on: 22 Mar 2013
Thanks to everyone who supported this project and voted for it in the Arduino Challenge! I was awarded second prize and hope to participate in more Arduino contests in the near future. This tutorial will explain a simple way to make a password protected bluetooth door lock using your Arduino, which can be unlocked by […]
Beginners guide to building Arduino robots with Bluetooth and Android
Posted on: 21 Mar 2013
In this tutorial we are going to go over building a Arduino robot that can be controlled via bluetooth with an Android phone/tablet. This is a beginners guide that is going to briefly go over the process of wiring and programming your robot. Build list… The following is the list of components we are going to use: 1. Pololu […]