The Smuggie: Tweet straight from your Snuggie using arduino




Want to tweet how satisfied you are cuddled up in your Snuggie? The Smuggie is a modified Snuggie, designed specifically for those who feel the need to express their smug satisfaction with a Snuggie to their friends on Twitter.
Here’s a list of everything you’ll need:

– Processing IDE (http://processing.org/)Arduino IDE (http://arduino.cc/)
– A Twitter account (https://twitter.com/)
– At least one Snuggie”
– 1 Arduino Main Board (http://www.sparkfun.com/commerce/product_info.php?products_id=666)
– 1 Solderless Breadboard (any size, the smaller the better)
– About 5-10 feet of 22AWG Solid Core Wire
– A needle and thread
– About a foot of foam core
– About a foot of Conductive Tape

By: Justin Blinder
http://blog.justinblinder.com

The Smuggie




Step 1: Writing the Code

Code
1) Download and Install Arduino/Processing (there are tutorials on each website on how to get setup).

2) Open up Arduino. The code below is basically going to program our Arduino to wait for a button press, and send a message to Processing every time the button is pressed. Copy the code into the Arduino window and plug your Arduino into your computer. Click the upload button at the top of the window. You’ll see a message on the bottom of the window that says “Done” once everything’s finished. Now our Arduino is all ready for coding.

Arduino Code
2) Now let’s pen up Processing. The following code is going to handle the following:- Connect to a remote Twitter client (so you can tweet from your very own Twitter account)
– Listen for a button press from our Arduino- If it sees that a button is pressed, send Twitter our status update

3) Copy and paste the code below into the Processing window. On the line that says:
String myStatus = “enter your status update here”;
replace the text “enter your status update here” with the message you’d like to tweet (leaving the quotes intact). Make sure your message is a maximum of 140 charecters, otherwise your Smuggie’s won’t tweet!

Step 2: Twitter Setup

Twitter Setup

Now let’s register our Twitter account with the Smuggie Twitter Client.  This will allow us to tweet from our processing application, using our desired Twitter name.

1) Go to the Twitter website and log into your account. Once your at the homepage, open the following link:

http://magichive.com/projects/smuggie/register.php

2) You’ll be asked to click a link will then be redirected to a page with a 7-digit number. Copy the number and insert it at the end of the following link, then load the link in your browser:

http://magichive.com/projects/smuggie/validate.php?pin=

Now we’re ready to start making our Smuggie.

The Smuggie

Step 3: Cut the Fabric

Alright, now we’re going to make a “soft switch”, which in this case is essentially two strips of wire wrapped in conductive material, that will be housed in fabric. When we press down on the fabric, the switch will close, which is what our arduino will be listening for in order to send a tweet.

 

For more detail: The Smuggie: Tweet straight from your Snuggie




Clip to Evernote

Leave a Comment

(Spamcheck Enabled)

Read previous post:
Very simple ECG + Pulse Oximeter using arduino

Scott W Harden has built an updated version of his ECG circuit for tracking his heartbeat. The main goal of...

Close
Scroll to top