USB Power supply Active Load Tester




USB Power supply Active Load Tester or short PAL Tester is unit designed for testing the quality of the power supplies.
Idea was to create low-cost, precise device for simultaneous measurement of Voltage and Current drawn from the device under test. This is one of my weekend projects that I have decided to release to the public. All source files can be found on projects GitHub page.

Device Features:

  • Open Source and Open Hardware
  • Modular design, easy to understand and change/adapt to your needs
  • Uses widely available and off-the shelf components
  • Components Bill of Material is below $10
  • Integrated USB-to-Serial converter for easier interface with the device
  • API for communicating with PC
  • Recording Voltage vs Amps data and graphing the results
  • Easy to use

USB Power supply Active Load Tester




Basic capabilities:

  • PSU under test max voltage 55V
  • Current Load of 5A (or more by changing Rs value)
  • Current and Voltage measurement accuracy is below 5%

Component list and estimated price:

  • 1x – PIC16F1829 [$1.6]
  • 1x – MCP6002 Rail-to-Rail OpAmp [$0.69]
  • 1x – MCP4726 12bit DAC [$0.96]
  • 1x – IRF L3705 Logic Level N-MOSFET [$0.5]
  • 1x – CH340T USB-to-Serial converter [$0.99]
  • 10x – 1 ohm 1% 1/2W resistor
  • miscellaneous (resistors and capacitors)

How to build your own USB Power supply Active Load Tester:

If you are going to use photo etching or toner transfer method to make DIY board, there are bottom layer printouts in the Hardware folder that are ready for you to print and create a board via your favorite PCB manufacturing technique.

For More Details: USB Power supply Active Load Tester




Clip to Evernote

Leave a Comment

(Spamcheck Enabled)

Read previous post:
Simple_Burglar_Alarm_Arduino
Burglar Alarm using Arduino and PIR Sensor

In this tutorial, we are building an interesting application using Arduino and PIR Sensor. A Burglar Alarm – is basically...

Close
Scroll to top