I have a $500 Rigol DP832 programmable triple-output power supply sitting on my bench, yet I built a 5V regulator to sit atop a 9V battery for some reason. Perhaps it’s more portable, or cheap enough to toss in with the rest of the project it is powering, or maybe the bench power supply is […]
If you can ride a bike with no handlebars, no handlebars, no handlebars, you can do just about anything. You can take apart a remote control, and you can almost put it back together. You can listen in on a two meter repeater and you can build a GPS module speedometer. That’s what [Jeremy Cook] did
THIS GPS SPEEDOMETER HANGS OFF YOUR HANDLEBARS Continue Reading
OpenScan has created a low-budget, high quality DIY 3D scanning system, that is fully open-source and modular and available to purchase in a variety of different packs depending on your needs from control board to full system. Based on Photogrammetry, the 3d Scanner is compatible with various cameras, so that simple smartphones or DSLR can
Arduino 3D scanner and photogrammetry rig €150 Continue Reading
Photographic slides were popular in the middle part of the 20th century, but are long forgotten now. If you’ve found a handful in a dusty attic, you might consider sending them away to be digitized professionally, or using a flatbed scanner at home. [Bryan Howard] found himself with over 200,000 slides, however, so that just
Since several years already, it is possible to find systems for home automation: irrigation, doors and windows, lighting, air conditioning and alarm systems, everything can be centralized and planned. Recently, the classical control boxes have been replaced by smart systems that are always connected to the Wi-Fi Network and that can be remotely accessed by
If you mention a clock that receives its time via radio, most people will think of one taking a long wave signal from a station such as WWVB, MSF, or DCF77. A more recent trend however has been for clocks that set themselves from orbiting navigation satellites, and an example comes to us from [KK99].
GPS Self-Adjusting Clock With An E-Ink Display Continue Reading
Gateworks Corporation announces the Newport Family of single board computers featuring eight standard models. These models range in size and features to provide a comprehensive and flexible solution to customers requiring a high performance, feature-rich embedded networking board. The Newport Family is based upon the Cavium Octeon TX 64-bit ARMv8 SoC, which has been designed
Newport Family of SBC Based on the Cavium Octeon 64-bit ARMv8 Processor Continue Reading
Potentiometers, or variable resistors, are a standard component that we take for granted. If it says “10k log” on a volume pot, than we fit and forget. But if like [Ben Holmes] you are modelling electronic music circuitry, some greater knowledge is required. To that end he’s created a rig for characterising a potentiometer to produce
CHARACTERISING A POTENTIOMETER WITH A STEPPER MOTOR Continue Reading
The Micro Maestro is the first of Pololu’s second-generation USB servo controllers. The board supports three control methods — USB for direct connection to a PC, TTL serial for use with embedded systems, and internal scripting for self-contained, host controller-free applications — and channels that can be configured as servo outputs for use with radio
Micro Maestro 6-Channel USB Servo Controller Continue Reading
Nanotechnology plays an indispensable role in modern materials research and new products. Carbon nanotubes (CNTs) enable production of novel materials with amazing properties. Progress is however not without risk and a recent study on mice has shown that certain types of CNTs have similar carcinogenic properties as asbestos fibers. So far there is no evidence of risk
Long-fibre carbon nanotubes shown to be carcinogenic Continue Reading
English 
French