This Arduino Nano Shield consists of a Light sensor, a Magnetic field sensor, and Temperature sensor. The shield can be used to develop various projects required light sensing, magnetic field sensing, and temperature sensing. All sensors provide analog voltage outputs, so each output is connected to analog inputs of Arduino Nano.
SENSORS
- OPT101 High Sensitive Light Sensor with Adjustable Gain ( Analog Output)
- DRV5053 Magnetic Field Sensor ( Analog Output)
- LM35 Temperature Sensor ( Analog Output)
ARDUINO NANO INTERFACE
- OPT101 Light sensor output connected to Analog pin of Arduino Nano
- Magnetic Field Sensor output connected to Analog pin of Arduino Nano
- LM35 Sensor output connected to Analog pin of Arduino Nano
OUTPUT
- OPT101 provides 7.5mV to 4V ( Minimum Dark Output 7.5V)
- DRV5053 Magnetic Field Sensor Output 0-1.8V
- LM35 Temperature Sensor Linear + 10-mV/°C Scale Factor
Power Supply: All Sensors connected to 5V of Arduino Nano
OPT101
The OPT101 is a monolithic photodiode with op-chip transimpidance amplifier. The integrated combination of the photodiode and transimpidance amplifier on a single chip eliminates the problems commonly encountered in discrete designs, such as leakage current errors, noise pickup, and gain peaking as result of stray capacitance. Output voltage increases linearly with light intensity. The power amplifier works on single supply. The 2.29mm X 2.29 mm photodiode operates in the photoconductive mode for excellent linearity and low dark current.
The OPT101 is a large-area photodiode integrated with an optimized operational amplifier that makes the OPT101 a small, easy-to-use, light-to-voltage device. The photodiode has a very large measurement area that collects a significant amount of light, and thus allows for high-sensitivity measurements. The photodiode has a wide spectral response with a maximum peak in the infrared spectrum, and a useable range from 300 nm to 1100 nm. from all-analog circuits to data conversion base circuits. The on-chip voltage source keeps the amplifier in a good operating region, even at low light levels. The OPT101 voltage output is the product of the photodiode current times the feedback resistor, (IDRF), plus a pedestal voltage, VB, of approximately 7.5 mV introduced for single-supply operation. Output is 7.5 mV dc with no light, and increases with increasing illumination. Photodiode current, ID, is proportional to the radiant power, or flux, (in watts) falling on the photodiode. At a wavelength of 650 nm (visible red) the photodiode responsively, RI, is approximately 0.45 A/W. Responsively at other wavelengths is shown in Figure 1. The internal feedback
Read more: MULTI SENSOR SHIELD FOR ARDUINO NANO WITH LIGHT, MAGNETIC FIELD & TEMPERATURE SENSOR
French 
English