Comment faire un servo et Ardiuno stand

In this instructible I will show you how I make my servo stand.  This stand is useful if you want to test a new way to control a servo but dont want to use a servo on your robot or something.  make

Step 1: Cut the wood

cut 2 5inch pieces of 2×4
then measure the short side of the servo and add 2inches then cut 2 pieces of paint stirrer to this measurement

Step 2: Put it togather

First -skrew the servo on to the paint stiks, there sould be 1 inch of stik hanging out each end.
Second -lay the servo asembaly on the 2x4s (laying flat on a table) and push togather until the 2x4s are touching the servo and nail the -stirrers to the 2×4 with the finish nails puting two in each piece.

Then lay your ardiuno on the wood and use the pencl to mark were the mounting holes are then drive the wire brads in to the marks (but only part way)

For more detail: Comment faire un servo et Ardiuno stand