Homebrew Arduino Pulse Monitor (Visualize Your Heartbeat)

Contenu masquer

1 Step 1: Find The Perfect Colthes Hanger

2 Step 2: Cut The Clips

3 Step 3: Disassemble The Clip

4 Step 4: Drill Holes

5 Step 5: Install The LDR

6 Step 6: Install The LED

7 Step 7: It Doesn’t Work

8 Step 8: Wire Them Up

9 Step 9: Download The Softwares

Movies look cool with those EKG (electrocardiogram), the one that beeps and detects heart activities. A few months ago, we had to shoot a hospital scene for our school project. We needed an EKG instrument. To keep the movie authentic, we didn’t want to fake the readings so we made the next best thing, a pulse monitor. Since my dad is a doctor he gave me some advice to design the pulse monitor.

Let me clarify this to you. This project works and can actually monitor your pulse. Due to the lack of research and experimentation, the homebrew pulse monitor cannot be used for medical purposes.

What Can You Do With It?
You can make a lie detector/ polygraph and tell who’s lying or not. When a person lies, you’ll notice a sudden change on the graph.

What Does This Guide Include?
– Arduino Codes & Processing 2 Codes
– Steps on making a pulse sensor
– The Virtual Graphing Software
– Schematic Diagrams

What Do I Need To Make This Project?
– A Grippy Clothes Hanger
– Clear/ Bright Red LED
– LDR (Light Dependent Resistor)

Future Questions:
Why isn’t mine working? For some reason LDRs (light dependent resistors) are not standard in resistance ratings. You’ll need a some tweaking to pull off the project, it may require experience with Arduinos and electronics.

This project is inspired by Make Magazine’s pulse monitor although my version didn’t use a LM324 Op-Amp chip. Their tutorial will work on my setup.

Step 1: Find The Perfect Colthes Hanger

This project works best with rubber padded hangers. Luckily “Marks & Spencer” gives away these hangers for free.

Step 2: Cut The Clips

Cut the clips off the hanger with a pair of heavy duty shears.

Step 3: Disassemble The Clip

Get your multitool and disassemble the clip.

Step 4: Drill Holes

Drill a hole on the exact center of the clip’s rubber pads.

Step 5: Install The LDR

Bend the LDR’s leads then mount them in place. Finally use hot glue to keep the LDR from moving.

Step 6: Install The LED

Get your led and use superglue to keep it intact with the clip. Also, you might want to add a resistor to protect the LED from getting busted.

Homebrew Arduino Pulse Monitor (Visualize Your Heartbeat) Schematic

Step 7: It Doesn’t Work

You’ll barely get a reading. If yours doesn’t work, use this circuit to amplify the readings. D1 is just an indicator and not the red LED that’s used to light up your thumb. It’s best If you use a 10k trimmer resistor for R3 rather than a fixed value resistor.

Step 8: Wire Them Up

Follow the diagram above. PCB/ perfboards are not necessary. Wires would do just fine!

Step 9: Download The Softwares

Processing 2 is the graph/ monitor software that will visualize your data while the Arduino IDE is for uploading the arduino sketch. You’ll need both to run the project. Click on the links below to download them.

For more detail: Homebrew Arduino De Pouls (Visualiser Les Battements De Votre Coeur)

Homebrew Arduino De Pouls (Visualiser Les Battements De Votre Coeur)