Everyone who´s ever tried to suck off a solder from a solder pad by means of a solder absorbing braid (wick) will probably confirm, that this tool belongs to a “must have” equipment of every professional or amateur workplace. What´s the charm of a desoldering braid? Above all in the fact, that it´s able to absorb almost all the solder from a given place, thus the most of components can be loosened very easily. Hand (pneumatic) pump surely has its place, mainly when working with bigger components, but at comparison with a desoldering braid it´s similar like if we compared a broom with a vacuum cleaner.
A quality desoldering braid is usually able to absorb a solder so thoroughly, that only a microscopic layer of a solder will remain on a PCB – as if a board was new, unused. It is very advantageous even at a hand rework of SMT components, because it´s desirable the component to lay directly on a board – not askew in a thick solder layer causing a mechanical tension and able to cause even a malfunction of a component (often at SMT capacitors).
To reach a good functionality of a desoldering wick it should be made of a fine gauge copper wires (without oil residues end similar) and it must be treated with a high quality flux. The cheapest braids usually contain only a rosin-based flux, the better ones have a synthetic flux based, which produce less fumes.
A novelty in our portfolio is the novelty from company CRC Industries – braid SOLDABSORB. We keep Soldabsorb in a width of 1.5 and 2.5mm, packed in a blister in 2 pcs (the price is for 2 pcs). Soldabsorb represents a top-level in this segment and is made of a highly pure copper, fine gauge wires and contains a synthetic NO-CLEAN flux. It means, that the flux residues are non-conductive and non-corrosive and they can be left on a PCB. Very fine wires contribute to a high wicking (absorbing) ability.
For More Details: Desolder professionally with NO-CLEAN flux wicks
French 
English