La Détection de la température de Chauffage du Système de Contrôle avec Arduino Mega2560

Web site:

http://www.icstation.com/product_info.php?products_id=3517

Project Summary:

To help electronic DIY hobbyists, will show you how to use Temperature Detecting Heating Control System with Arduino Mega2560.

Full Project:

The temperature detecting heating control system works with DC5V voltage. This system uses DS18B20 temperature detection chip as the external detection equipment.
It works according to the external temperature collected by DS18B20. The system can make the heater work according to the temperature which has been setted. When the actual temperature is lower than the setting temperature, the heater begins to heat to make the temperature go up. When the heating temperature is not lower than the setting temperature, the heater stops working, the buzzer will alarm.

Step 1: Schematic Diagram

Step 2: Power Supply Line & GND Line

Step 3: LCD1602

Step 4: Digital Tube & MEGA2560

According to the schematic diagram, connect the pins of 4bit Digital Tube with the pins of ICSTATION MEGA development board.

Step 5: Place the Buzzer

Step 6: Connection of DS18B20 & Keyboad

Step 7: Connection of the Relay Module

The relay VCC and GND respectively connect to the bread board “+” “-”, and connect to the development board pin 13.

For more detail: La Détection de la température de Chauffage du Système de Contrôle avec Arduino Mega2560