MP3 Shield




MP3 Shield description:

The MP3 Shield wires your Arduino up to a VS1053D MP3 audio decoder IC, providing it with the ability to decode audio files. The VS1053 is also capable of decoding Ogg Vorbis/MP3/AAC/WMA/MIDI audio and encoding IMA ADPCM and user-loadable Ogg Vorbis.

The VS1053 receives its input bitstream through a serial input bus (SPI). After the stream has been decoded by the IC, the audio is sent out to both a 3.5mm stereo headphone jack, as well as a 2-pin 0.1″ pitch header.

MP3 Shield




MP3 Shield specification:

MP3 Shield pinout:

MP3 ShieldNote:
D0: TX
D1: RX
D2: BSYNC/XDCS
D3: DREQ
D4: GPIO2/DCLK
D5: GPIO3/SDATA
D9: CS/XCS
D11: MOSI
D12: MISO
D13: SCK

 

For more detail: MP3 Shield




This Post / Project can also be found using search terms:

  • arduino mp3 shield
Clip to Evernote

Leave a Comment

(Spamcheck Enabled)

Read previous post:
Motor Shield

Motor Shield description: This is a motor shield for Arduino that will control two DC motors. Based on the L298...

Close
Scroll to top