Mini Fluxer will spread solder there, where you want




Mini Fluxer will spread solder there, where you want

… and will prevent to spread there, where you don´t want to. Fluxes in pen Stannol series Mini Fluxer belong to the invaluable helpers of every electro-technician.

Mini Fluxer will spread solder there, where you want




How could I work without a flux so far? That´s a probable question of probably everyone, who once tried action of a solder flux. In a common wire solder, there´s some amount of a flux, usually sufficient for one-time soldering of a given joint, if the components to be soldered are clean and oxides-free. However, we know well a case, when we use for example an older PCB, or an older component with slightly oxidized leads and suddenly it´s much harder to reach an acceptable joint. Similar situation happens at an exchange of a component or any service action, when a solder tends to oxidize on a surface and create various bad-looking creatures, which are quite far from a professional joint. Fortunately, there´s a flux here … In general, fluxes act in a manner, that a solder is as if „more movable“ after application. It is mainly thanks to the protection against oxidation, change of surface tension and other influences. As a result it means, that a solder spreads well on metals and joints with a given material (what we naturally want) and on the non-metal substances (PCB) is a solder repelled as if on an oily surface.

 

For more detail: Mini Fluxer will spread solder there, where you want




Clip to Evernote

Leave a Comment

(Spamcheck Enabled)

Read previous post:
ESP8266 Wifi Temperature Logger

They day I read at hackaday (http://hackaday.com/tag/esp8266/) that a new $5 wifi module was available, I order a few of...

Close
Scroll to top