More Awesome DoorBell Control




My first DoorBell Mote prototype was working nicely and it allowed monitoring the door bell (while also triggering it remotely – toddlers love it). But I wanted more. On weekends the family likes to get a well deserved nap during the day and often those pesky solicitors ring the bell and wake everyone up. So naturally the doorbell has to be disabled also, without major effort or any disconnected wires. Sounds like the perfect addition to the Door Bell Mote. So I made a new revision and a proper PCB for this, below is the schematic with the changes and the proto PCB from OSHPark. Actually I made more changes to the schematic after putting together the PCB, so there are some differences. I’ve tried a LTV814H optocoupler for AC detection instead of the more expensive H11AA11, it works just as well, but both can be used on this PCB:

More Awesome DoorBell Control




There are 2 regulators on this PCB. One is a 12V linear LM7812. The second is a 3.3V linear regulator getting input from the 12V LM output, both in TO220 packages. I know they are super inefficient to convert rectified 16VAC to DC voltages and the critics will stone me for doing this. But here’s the deal – the linears are about 50cents each and I had both among my junk parts. An efficient switching regulator is somewhere between $5-$10. The linears run somewhat warm. The 3.3V regulator only gets warm when I use the disable relay. So they can get warm but not hot, which is fine by me, it’s just a tradeoff. I might make a new revision where I have a single switching regulator such as this one, a drop in replacement for the LM linear regs.

Modes of operation: detect and trigger

If I just want to use this as a bell detector and trigger a ring, I can wire it as before, 3 simple taps, into the first 3 terminals (“GND”, AC, and trigger). The terminals from the transformer are AC so there is no ground, but I marked one of the wires as “GND”, this is our virtual ground for the DC part of the circuit, the other provides our DC rectified output:

FOr More Details: More Awesome DoorBell Control




Clip to Evernote

Leave a Comment

(Spamcheck Enabled)

Read previous post:
How to Make an Arduino Powered Lamp Dimmer
How to Make an Arduino Powered Lamp Dimmer

Ever wondered how to bring an Arduino board into your daily life? We often adjust the display brightness of our...

Close
Scroll to top