0 to 99 Light display




this circuit will take a light reading then display a number between zero and 99
0 to 99 Light display




please leave constructive comments

Step 1: Parts you will need

Major Components in Project

to make the 0-99 LED display you will need…

~ photo resister
~ Arduino
~ 9 different wires
~ 2 seven segment led displays
~ bread board
~ staples
~ fine grit sandpaper
~ and a stapler

Step 2: The Code

This is the code for the Arduino

I tryed to explain it the best i could in the comments but i ran out of room in some of them

so lines of interest

int pinstringA[11] {
HIGH,LOW,HIGH,HIGH,LOW,HIGH,HIGH,HIGH,HIGH,HIGH};

these strings code for the state of one segment each so
pinstringA[0] == HIGH   this means that when the number is zero segment A is High

light = map(light, 0, 1024, 100, 0);
the pullup resister flips the values of the photo resister so a lot of light makes the number low
so I Changed the scale from 0 to 1024 to 0 to 100 then flipped it.

tens = light / 10;
this finds the tens value eg. 19/10= 1 remainder 9 the remainder is then thrown out
the line below saves the remainder for the ones place

PORTD = PORTD & B00000011;
this turns all the pins on port d off but leaves pin 0 and 1 alone (for serial communication)
see http://arduino.cc/en/Reference/PortManipulation for more details

Step 3: STAPLES!!?!

STAPLES

With the code downloaded you need to connect the board
you need to connect the corresponding pins together so pin one
of one display connnects to pin one of the other display

Staples works very well for this they are six pins in length the only
bad part is that the glue that holds them together is non conductive so
take the sandpaper and rub off the glue on the downward leads
next pop them in a stapler and use it to push the acual staples apart

push them into the bread board leaving room for the display and wires
to connect to Arduino.

Step 4: Attach wires

attach wires to the led

Step 5: Connect to Arduino

connect each wire to the Arduino

segment A to pin 4
B to 7
C to 8
D to 6
E to 3
F to 2
and G to pin 5

also connect ground from ones place to pin 9
and ground from tens place to pin 10

last connect the photo resister to the Arduino ground and Analog 0

 

For more detail: 0 to 99 Light display




This Post / Project can also be found using search terms:

  • arduino uno led projects
Clip to Evernote

Leave a Comment

(Spamcheck Enabled)

Read previous post:
SSD1306 OLEDs – DMA Library for Arduino Due

So we're always cooking up hot new hardware in the Grav Corp labs. Recently, we've been working on a project...

Close
Scroll to top